> From: Harvey Peekar
>
> so, i pulled my chroma out last night and began the process
> of removing/cleaning the front panel. unfortunately, as i
> was trying to take off the ground nut the whole screw broke
> off and im left with a little nub where the bolt would go.
> would it be ok for me to just solder the grounding wire to
> the panel where the screw once was? i suppose i could also
> just solder a new screw and bolt, but im not sure if
> soldering grounds the same like it was before. much thanks!!

It's almost impossible to solder to a big piece of steel. Better to put the
lug on the nearby panel board mounting screw.

--

Ciao, Paul D. DeRocco
Paul mailto:pderocco@...