previous by dateindexnext by date
previous in topictopic listnext in topic

Subject: RE: [chromapolaris] Volume adjustment

From: "Paul D. DeRocco" <pderocco@...>
Date: 2011-07-01

> From: Dan Stefacek
>
> My Polaris has worked fine for many, many years. It has been
> turned on pretty much nonstop for 20 years. No problems.
> Recently I did a rare live show, and turned the beast off to
> move it. When I turned it on again, all the panel LEDs lit
> and there was no sound. Unplugging and replugging the pedal
> and sustain switch jacks seemed to clear up the problem. LEDs
> went back to their regular behavior and the correct sounds
> returned. When I moved the synth back home, I got the same
> weirdness with the LEDs all lighting and no sound, but
> replugging jacks and cycling power didn't have any effect for
> a day or so. Then, about a day later, it seemed to work: the
> LEDs went back to their correct settings, and the sounds came
> back. But they are all at about a quarter of their previous
> volume. I tried doing the adjustments listed on page 108 of
> the manual. But there is a problem with those directions.
> They instruct you to "turn the MASTER slider all the way up",
> and then to "raise the MASTER slider until you hear the note
> just begin to bleed through". I don't understand how you can
> raise the slider any more after it is "all the way up". I
> haven't had any luck playing around with this. I have tried
> pressing LF, Adjustments,9 twice, without any perceptible
> change. Anyone ever run across this weirdness? Thanks!!

I think that means that you begin by turning the master volume all the way
up, so you can better hear the bleedthrough when you begin to do the actual
adjustment.

--

Ciao, Paul D. DeRocco
Paul mailto:pderocco@...