Probably even the lower section of the A-185 could solve the problem if the
bus jumper J1 is removed (used to connect the output of the CV buffer to the
A-100 bus board). The lower section is nothing but a buffer with two
parallel outputs (it's labelled "CV" but the circuit can be used for audio
signal as well).

But as I have our system not availble I cannot test your special patch
before next week.

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von bellenger_a
> Gesendet: Montag, 22. Mai 2006 18:55
> An: Doepfer_a100@yahoogroups.com
> Betreff: 1 Re: Very "candide" idea for new module...
>
>
> > If I get you right, here's *my guess*: The A180 is a passive device
> > thus the A196 is loading back on the A117.
> sounds like this yes
>
> >Analogue Sol.'s MX224 should solve that prob.
> Oh yes you're right thank you, I just checked on their site...
> Mmmh, so no solutions with
> Doepfer fo this now... So that's why I was thinking about such
> module but maybe more
> elaborate than the analog solutions one
>
>
> Alexandre
>
>
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>