You find my answers written inline.
Best wishes
Dieter Doepfer
> i'm putting together a doepfer expansion rack...i got most of it
> together, but i'm not 100% sure how to apply ac to the power
> supply (the psu2, the newer one).
>
> i see how to hook the buss to
> the power supply...i'm mounting the power supply to steel rails
> and will run ground to the rack chassis/earth ground/ground the
> rails to the chassis...basically i just need to know which pins
> to put the hot and neutral ac to the doepfer pwoer supply, and
> i'll test the dc power out before plugging in and mods...also,
> i'm using an in-line fuse holder, i assume that goes on the ac hot
Even if I say it again....
The PSU has to be installed by qualified personnel only. If you are not
familiar with electronics and installation of parts that are connected to
mains voltage please do not try to install the PSU!
If you are familiar with electronics and the safety rules in your country
you find the corresponding information on our website: www.doepfer.com > FAQ
> How is the wiring of mains inlet, power supply and bus boards
> another thing: from the doepfer site, it's a bit unclear how to
> plug the mods into the buss..they all have the ribbon cable
> plugged in, where does the red wire go thinking about it now i
> probably just have to look at the cb of the mod and match the singnal...
Please look at the A-100 user's manual, basic part (introduction) on pages 4
and 5. If you do not have it's available for download on our website:
www.doepfer.com > MANUALS > A-100 > A100_intro_e.pdf
> i'm asking on AH/Doepfer List as Analogue Haven is closed until
> monday and i'm just plugging stuff in at this point, my self
> assembled rack case is ready to go...and i'll hold no one libel
> if i fuck up (haha)....please feel free to email me directly, i'm
> on the digest (AH)...
>
> thanks,
> rg