that sounds great.
so, i guess these will be the feauters of an advanced vc sampler/wavetable module. ok
 


Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist
1 group owner
www. parallel - worlds - music. com
www. myspace. com/ parallelworldsmusic
www. myspace. com/ interconnectedmusic
www. myspace. com/ memorygeist
www. DiN. org. uk
www. musicamaximamagnetica. com
www. shimarecords. co. uk
www. rubberrecords. gr
Athens - Greece

--- On Thu, 10/30/08, Florian Anwander < fanwander@... > wrote:

From: Florian Anwander < fanwander@... >
Subject: Re: 1 Sampler CV/Gate Recorder - was: bright new ideas for future Doepfer A100 modules!
To: Doepfer_a100@yahoogroups.com
Date: Thursday, October 30, 2008, 2:21 PM






Hi Stu

I have some addon features for this:
> 8/16 (maybe also 24 ) bit sampling

> gate (not trigger) for play/record
replace this by:
gate(+switch) for run/stop
gate(+switch) to select between single shot / loop mode
gate(+switch) to switch from gated mode to so called "release-mode" (if
in single shot, the sample should be played to the end; if in loop mode,
the loop should be played endlessly until the next start/retrigger is
given).
trigger(+momentary- switch) for restart
trigger(+momentary- switch) for start
trigger(+momentary- switch) for stop (use case: two samples eliminate
each other, like hihat/openhat) .

> gate to select play or record
This record setting should be an pre-enable setting; the real write
setting should be done by the start signal.

> cv input for sample rate
> cv input to scan through sample
cv inputs for start point / stop point / perhaps also loop start
(similar to the editing the Akai S612)

> separate audio outs for monitoring (which i don't need in my patches)
> and playing (to avoid phasing and volume problems associated with
> hearing the original signal and monitor signal together)
>
> a stereo version would have the advantage of being usable to record cv
> and gate signals for use as a sequencer.
The module should be mono, but there should be the possibility to link
several modules by the clock and the address bus, so it would become
stereo or even multi-channel. The write/play selector should stay
independent on each.

There should be either two (switchable) inputs and outputs: one
AC-coupled for Audio, one DC-coupled with suppression of negative
signals for recording CV and/or gate.
Or the module should be produced basically as the identical module but
in two versions. One ac-coupled for Audio, one for dc-coupled for CV/gate.

The dc-coupled version might have additional three
trigger-in/momentar y-switches for
- count RAM-address one step forward
- count RAM-address one step backward
- write input value to actual step.
This would be similar to the programming of the roland CSQ-600.

Florian

















[Non-text portions of this message have been removed]