hi Miguel,

assuming that you have flipped the 'master' switch that enables the A154 to control the a155:

you do have pushed 'start' in the a154
you have not put the a154 running mode into one of the 'one shot' modes
you have not put the a154 running mode into the 'cv control' mode
you do have the 'first step' knob full CCW and the 'last step' knob CW
you do NOT have a constantly high gate signal into the reset input of the a155 or the a154

then, if all these are right, and you have connected the a155 to the a154 correctly and the a155 is not stopped (just press the start button on the a155 as well, to be sure), the a155 should run with the speed of the a154 clock...


Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist

1 group owner

www. parallel - worlds - music. com

www. myspace. com/ parallelworldsmusic

www. myspace. com/ interconnectedmusic

www. myspace. com/ memorygeist

www. DiN. org. uk

www. musicamaximamagnetica. com

www. shimarecords. co. uk

www. rubberrecords. gr

Athens - Greece

--- On Sat, 10/31/09, miguel < ventrality@... > wrote:

From: miguel < ventrality@... >
Subject: 1 a154 doubt
To: Doepfer_a100@yahoogroups.com
Date: Saturday, October 31, 2009, 11:04 PM






 





hi friend, i need a bit of help



recently i installed the a154 controller to drive my a155, i think the connections between are ok (everything seems to be right, clock speed flashing, etc),but when i press start in the a154 the sequencer don t run, have i to connect any patch apart from the cv- gate usual ones i used the a155 alone with no problem at all...



many thanks in advance



miguel































[Non-text portions of this message have been removed]