Hello Florian

Thanks for the quick reply! I am waiting on a logic module in my next shipment from Schneidersladen, so i will try this out once it arrives.

The multiple approach seemed to work though. Even if i got signals from the A-160 and the A-161 at the same time. I just got a bit worried when the diodes lit up by getting signal on the output. I was thinking i might risk damaging the modules.

Thanks!

//Peter

--- In Doepfer_a100@yahoogroups.com , Florian Anwander <fanwander@...> wrote:
>
> Hello peter
>
> > What i do is that i connect 3 of the gate outputs from the A-160 and and the A-161 to a multipple and then connect the 4:th multipple connector to the gate input on an anvelope generator. I have noticed that when i do this the leds on all connectors (on the A-160 & A-161) that are connected to the multiple light up when any of them is trigged.
> >
> > What i am wondering is if it is correct to use a multipple to "mix" the gate signals from the A-160 & A-161 like this Or should i be using some other module to do this
> No. It is possible to do this with the A161 (which enables always only
> one output at a time), but not with the A160, which enables several
> outs. The correct way for the A160 would be the A186 trigger combiner
> (or more expensive the A166 Logic module in OR mode).
>
> Alternatively you might use also a Mixer instead.
>
> Florian
>