--- buechlerjoe < buechlerjoe@... > wrote:

> > I have a question: being new to the Doepfer A100
> (System 2, with
> > Midi), what connections should I make between an
> old Roland System
> > 100 and the Doepfer so I can use the Doepfer on
> it's own midichannel
> > in Cubase, and use the Doepfer to make the System
> 100 midi on a
> > separate channel Can this be done Or do they end
> up on the same
> > midichannel
>
> The basic system 2 comes with an A190 midi/cv
> interface, which is a
> single-channel interface. You can use the A190 to
> trigger either the
> A100 or the Roland, but not on two different midi
> channels at the same
> time. If you want to do that, you should get an
> additional midi/cv
> converter.
>
> > If that is the case, how do I interface the System
> 100
> > and the Doepfer so that I can use the oscillator
> from the System 100
> > on the Doepfer
>
> As far as I'm aware, you can patch the System 100
> VCO right into the
> Doepfer mixer, vcf, or whatever you'd like.
>
> Hoper this helps.
>
> Joe
>
>

if you want to , try multing the CV and ate out of the
190, then go about patching the Doepfer as you would,
but also tahe the othe outs from the mults annd using
them to power the 100M, you could get a cool effect if
you have 2 inverters. invert the CV and Gate from the
multe, and then send them to the 100M

as Joe was saying, you can use any module from one,
with the other, any way you want.

__________________________________________________
Do You Yahoo!
Yahoo! Health - Feel better, live better
http://health.yahoo.com