My recommendation is to use the single step to adjust each note of the
sequence. Move the knob CW until the next semitone beyond the wanted tone is
generated. Then turn the knob CCW until the semitone below the wanted tone
is generated. Then turn the knob into the middle of these two positions.
Then you should be in the "center" of the right tone and no toggling (e.g.
D/D#) should occur. I know that's a bit long-winded but it's a solution.

Best regards
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von aletropdj
> Gesendet: Mittwoch, 14. Dezember 2011 14:57
> An: Doepfer_a100@yahoogroups.com
> Betreff: 1 Re: A-156 problem
>
>
> :/
>
> So I'll never have a solid sequence...
> i will try again.
>
>
>
> --- In Doepfer_a100@yahoogroups.com , <yahoo@...> wrote:
> >
> > > Hi.
> > >
> > > My quantizer is crazy.
> > > The connection i normally use is:
> > >
> > > A155 > A156 > A110/A140
> > >
> > > The problem is the pitch. the notes is not always the same.
> > > If my patern is C,D,C,D; at some time change for C,D#,C#,D...
> > >
> > > The gate not always trigger. at some time dont trigge one step.
> > >
> > > What is the problem and how i can solve
> > >
> > > Thanks
> >
> >
> > I don't think that your A-156 is crazy. You describe a basic
> "problem" with
> > each quantizer that is not embedded into the sequencer. A
> quantizer regrades
> > incoming voltages and does not "know" anything about a sequence and the
> > notes/voltages of the sequence (you could use any voltage as
> input of the
> > quantizer). If the new incoming voltage is very close to the threshold
> > between two steps (e.g. D and D#) the output voltage may sometimes
> > correspond to D and sometimes to D#. This could be avoided only by a
> > quantizer that "knows" that during the last sequence there was
> a "D" at the
> > step in question and that he has to repeat this "D" because
> there is only a
> > very small difference between the new voltage and the voltage during the
> > last run.
> >
> > To obtain this feature the quantizer would have to memorize the
> voltage of
> > the sequenzer step in question during the last run and compare
> it to the new
> > voltage. If the difference is less than e.g. 1/24V (half
> semitone) the same
> > output voltage is generated as during the last run. This is
> possible only of
> > a "supervisor" is available that memorizes the voltages of all
> steps during
> > the last run and compares it to the voltages of the next run.
> But as A-155
> > and A-156 are separate modules that's not possible. Only a
> sequencer with
> > built-in quantizer (like the Dark Time) could offer such a feature.
> >
> > It's a bit difficult to understand but I hope I could explain the
> > A-155/A-156 behaviour.
> >
> > Best wishes
> > Dieter Doepfer
> >
>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>