hi tony,

forgot to say, i am using Intellijel Buffered Multi, not the A-180.
but from the DI then where you plug the signal

--- In Doepfer_a100@yahoogroups.com , "Ton Akveld" <aca@...> wrote:
>
> Hi Marco,
>
> Thanks for the description!
> I route my end signal through a multiples so I can send one to the di-box and amplifier and the other to the oscilloscope (see http://groups.yahoo.com/group/Doepfer_a100/photos/album/1838015066/pic/57965373/view picmode=&mode=tn&order=ordinal&start=1&count=20&dir=asc)
>
> Regards,
>
> Ton (when in Sicilia: Nino :-))
>
> --- In Doepfer_a100@yahoogroups.com , "marco_zambardi" <marco.zambardi@> wrote:
> >
> > Hello Tony,
> >
> > yes, my external line mixer (a behringer eurorack pro) get a mono signal (Left/Mono In used) and split it on my Left and Right monitor (of course there is no real stereo fx in this case, the same signal is brought to L and R).
> >
> > this works both in case a multiple is used in patch and in case no multiple is used in the patch. but i always pass through a VCA (intellijel uVCA or Doepfer A-131 exp VCA) as last module before the mixer.
> >
> > Marco
> >
> > --- In Doepfer_a100@yahoogroups.com , "Ton Akveld" <aca@> wrote:
> > >
> > > Hi Marco,
> > >
> > > Thanks for thinking with me ;-)
> > >
> > > You write:
> > > > i have my external mixer bringing the mono-signal to L and R speaker.
> > > Does it still after routing through a multiples
> > >
> > > Love to hear!
> > >
> > > Ton
> > >
> > >
> > > --- In Doepfer_a100@yahoogroups.com , "marco_zambardi" <marco.zambardi@> wrote:
> > > >
> > > > strange...
> > > > usually modules use mono jack in and patching them with a stereo cable have no effect since there should be no connection (except for modules with a switch in the jack in to break normalled connection).
> > > >
> > > > i have my external mixer bringing the mono-signal to L and R speaker.
> > > >
> > > > i will have a try.
> > > >
> > > > --- In Doepfer_a100@yahoogroups.com , "Ton Akveld" <aca@> wrote:
> > > > >
> > > > > Dear group,
> > > > >
> > > > > Just like Bakis I want to wish you all a good 2012!
> > > > >
> > > > > But now, something completely different.
> > > > >
> > > > > When plugging in headphones in an audio out connector (VCA, mixer) I hear both the left and right channel.
> > > > > However, if I route the audio out through a multiples, the audio signal is halved, only the left channel is left.
> > > > > Is this caused by a difference in the audio out and multiples connectors
> > > > > Hope someone can tell.
> > > > >
> > > > > Warm regards,
> > > > >
> > > > > Ton
> > > > >
> > > >
> > >
> >
>