test

Thanks Florian (and thanks again for the SPV-355 info!)

I will look into changing the caps, but the mod I was referring to was the "External Input to Comparator" that I posted here a week or two ago, which I did to access the comparators in both the A-199 and A-142.

But as Dieter pointed out, the more I considered this patch, the less I believed it would work. The AND output would be a gate stream at audio rate, rather than a held-high gate. If Dieter's future "gate delay" module could be adapted to delay based on the FIRST zero crossing ONLY, that might work, but I wouldn't know how to design such a circuit.

Dieter, would the signal based on CV changes be similar to the Gate Out on the A-156

Nick

Sent from the future

On Nov 14, 2013, at 8:39 AM, Florian Anwander < fanwander@... > wrote:

Hello Nick

Am 14.11.2013 13:47, schrieb Nicholas Keller:
> Rats. Now I really wish I had an A-164 to try this instead of my
> positive-only, modified A-119/142s.
>
> If hard sync resets the VCO to the lowest point, and my threshold is at
> 0V, maybe it will still work for me.
Since you have modified modules you seem to be able to solder.

If you want to avoid clicking with the A-142 at low frequencies, then
simply increase the capacitor
If it is an A-142(-1) I suggest to add a 47nf cap to the existing cap
If it is an A-142-4 I suggest to add a 100nF cap to the existing cap
See
http://www.doepfer.de/DIY/a100_capacitors.htm

I have a A-142-4 and have the lower two envelopes with larger caps then
the upper two envelopes

Florian

previous	index	next
<<	topic list	>>

25175 Re: 1 RE: Newbie question about A-190-1 and A-145