test

I noticed some different behaviour of my A156's when testing my setup.

With a tuner on an A110 tuning from the A155 from C to C (seq knob fully ccw and cw) some came to C or B and when switching between 1V 2V and 4V it was not consistent.
So.... Time to make voltages visible.

Yesterday I finished fine tuning my four A156's and five A155's.

Once you know the drill it's not difficult, all it takes is some time and a precision voltage and measurement.

I used the A185-2 as a voltage source

and a Jones O'Tool Plus oscilloscope with a dual screen for voltage measurement in mV.

One input as source, the other from the A156.

As Dieter said, watch the offset.

Switch your precision adder between 0V and 4V.

I noticed there was a different quantizing sometimes (after regulating the P4 first!) when switching between 1V and 4V.

Then it made one step (note) to far (up). Then the P1 (cv1) or P2(cv2) comes in handy to regulate the threshold of the quantizer.

It acts as an attenuator, you can set quantizer steps earlier or later.

I made a list with calculated steps from 0,0833 to 1.000V and so it's easy to check where the threshold is for every step.

I used the attenuator from the 185-2 to walk through those steps and regulated that quantizing takes place at about 0,015V before the next step (note voltage) which leaves enough room for "minus offset" sequencer voltages.

Cheers

Good luck

Jacco Ville

Verstuurd vanaf mijn iPhone SE Lunatik

Op 19 aug. 2016 om 16:59 heeft Nicholas Keller maq163x2@... 1 < Doepfer_a100@yahoogroups.com > het volgende geschreven:

I hadn't thought to check the 156 for adjustment. I've been struggling with tuning for some time now and almost always have a 156 in the patch. Thanks for bringing this to my attention. I'll check the scale of my 155 while I'm at it!

On Thursday, August 18, 2016, Jacco Ville jaccoville@... 1 < Doepfer_a100@yahoogroups.com > wrote:

....And I certainly will do that.

Learning learning....

Funny thing, I am more collecting and adjusting my Doepfer setup (or Dieter room as my wife is calling it) then making sounds.

But I think it is the best way to know the working of every part of this system.

Cheers

Jacco Ville

Verstuurd vanaf mijn iPhone SE Lunatik

Op 18 aug. 2016 om 12:19 heeft yahoo@... 1 < Doepfer_a100@yahoogroups.com > het volgende geschreven:

> .... By the way ;-)
>
> I found out the attenuator function of P1 and P2
> Very handy to set the threshold of the quantizer behaviour.
> I noticed that with critical voltages from my A155's with a knob
> fully cw the voltage of 0.970V in 1V modus was not enough to get
> a full scale from C to C.
> Now I made the threshold of the A156 a few mV earlier to deal with
> this problem.
>
> Cheers
>
> Jacco Ville
> The Netherlands

That's a solution. But the correct way would be to adjust the A-155 so that
it outputs 1.0V in 1V mode. For this a trimming potentiometer (P9') is
available on the upper A-155 potentiometer board.

Best wishes
Dieter Doepfer

previous	index	next
<<	topic list	>>

27137 Re: 1 Tuning references for A156 quantizer