--- In Doepfer_a100@yahoogroups.com , "Dieter Doepfer" <hardware@...>
wrote:

>
> A1k,
>
> the 4-strip ribbon cable is not an accessory that we offer. Maybe

the former

> customer has added this cable (or it is offered by the Doepfer
> representative in your country).
>
> Yes! thanks Dieter, EMIS is the representative in the UK, I will
> be contacting them tomorrow and buying a bus-link connector.
>
>
> The only accessory that is a bit similar is the "A-100BC CV/Gate bus
> connection cable". But this only a 2 pin cable with a jumper

soldered to

> each side of both cables. The cable (or even one wire only) can be

used to

> connect the CV and/or Gate lines of 2 bus boards. E.g. if the A-190

is

> located in the lower row and you have one or two VCOs in the upper

row the

> CV line of the lower bus board can be connected to the CV line of

the upper

> bus boards by means of this cable. For this the CV and Gate pin

headers on

> the bus boards are used.
>
> This is the cable I need to get, it's only £2.00 to buy :)
>
>
> Details on page 9 and 10 of the A-100 user's manual (pin

headers/jumpers

> J1,J2).
>
> Pay attention that only one module is allowed to put CV and Gate to

the bus

> (e.g. A-190 or A-185, not both). Otherwise a short circuit of two

CV or Gate

> outputs is the result. Details in the user manuals of A-185 and A-

190.

>
> I only have two A-190's, one is in each seperate G6 case and are
> both independant from each other
>
> Gruss,
> A1k
>
>
> Best wishes
> Dieter Doepfer