Oct 31 9:16 AM
Yes, those resistors are just additional heaters for each vco. The ssm2033 has built in heaters, but they take a while to really get up to temperature. Especially when the ambient temperature is quite cool. That's why korg added the resistors with thermal compound on each vco. Not a tempco, just an additional heater. With the additional heater the monopoly should be stable within a minute or so. Pretty big difference.
-Steve
On Thursday, October 31, 2013, wrote:
1 New Message
Digest #436
Message
Wed Oct 30, 2013 10:06 am (PDT) . Posted by:
dir_marillion
Hi, thanks to Steve, I checked the resistor at first.
It was dead.
I replaced it and needed some calibration work to bring the VCO4 back to the same tuning as the other 3 VCOs. Now the 4 VCOs work stable in any octave and waveform.
Please notice that if a resistor is dead in any VCO, this oscillator comes slower than the others to the perfect & stable tuning. The time depends on the room temperature, it may comes earlier, especially in the summer.
---In korg_mono-poly@ yahoogroups. com, <dir_marillion@ ...> wrote:
Hello,
To a recent repair of my Mono/Poly, engineer had to remove the VCO thermal grease over the chip. Then he replaced it with another compound/paste and for a few weeks the instrument was working perfect.
Now, when I turn on the Mono/Poly the first 3 oscillators come to the same tuning after 10-15 minutes (the most) but the 4rth VCO comes synchronizes with them after 25-30 minutes.
What kind of thermal paste do you suggest for the Mono/Poly
Do you suggest to use this paste to all 4 oscillators or only to VCO 4
Will this thermal paste work or VCOs need a special paste
http://www.radiosha ck.com/product/ index.jsp productId= 2216880
Thank you very much