Hi,
My original question was about the original RAM patches 000-199 that shipped with the M-1000.
There is a file in the files section of this very Oberheim yahoo group for these patches, but I can only find patches 000-100 (100 patches being @27KB) when I send sysex to M-1000.
There is only one 27KB file in the zipped archive. Does this mean that the file for patches 100-199 are missing, or are they hidden away inside the one 27KB patch file and I am doing something wrong when I am sending that sysex file for patches 000-199 to my M-1000.
Cheers

--- In oberheim@yahoogroups.com , wolzow <margus.kliimask@...> wrote:
>
> Hi,
>
> First, there is no Send All sysex command in M-1000 MIDI spec. The 27K file
> is a set of 100 (ie. 1 bank) individual Single Patch Data sysex commands:
> single patch = 275 bytes transmitted. You have to set the active bank first,
> the following sysex commands assume this bank. It's not a problem of M-1000,
> MIDI specification simply is limited to patch numbers 0..127 only, if a
> device allows more, it has to use banks.
>
> Pls see the correct sysex docs (there are numerous errors in the printed
> manual) here:
>
> http://www.wolzow.com/analog/m1k-midi-spec.htm
>
> < http://www.wolzow.com/analog/m1k-midi-spec.htm >BTW, there's a note: "A gap
> of at least ten msec should be allowed between patches when sending
> multiple patches to the M-1000."
>
>
> On Fri, Jan 21, 2011 at 9:00 PM, cyllall <cyllall@...> wrote:
>
> >
> >
> > Hi,
> > The manual says the Matrix-1000 doesn't need to be in any special mode to
> > receive a patch dump,... it should switch banks automatically
> >
> > Anyway, I dumped patches 200-299 from my Matrix and the sysex file was
> > @27KB, the same size as the original RAM file in the files section here. I
> > take it then that 100-199 is missing from that file
> >
> > Cheers
> >
> >
> > --- In oberheim@yahoogroups.com <oberheim%40yahoogroups.com>, Paul
> > Cunningham <paul@> wrote:
> > >
> > > the sounds on the matrix-1000 are organized into banks of 100... before
> > you load up the 100-199 bank, change your bank to bank 1 and turn on bank
> > hold, and they should load into the correct location. -pc
> > >
> > > On Jan 21, 2011, at 11:55 AM, "cyllall" <cyllall@> wrote:
> > >
> > > > Hi,
> > > > I've sent the sysex file to my M-1000 for the original RAM patches, but
> > only 000-100 are there, 101-199 are missing. Am I doing something wrong, do
> > I have to adjust the timing of the packets . I used MIDIOX.I recently
> > re-initialised the M-1000 after changing the battery.
> > > > Thanks
> > > > Martin
> > > >
> > > >
> > >
> >
> >
> >
>