Feb 15, 2017
the Matrix 6 will be back on the bench this morning, thanks for the replies....
From: "John Leimseider john.leimseider@... [oberheim]" <oberheim@yahoogroups.com>
To: "oberheim@yahoogroups.com" <oberheim@yahoogroups.com>
Sent: Tuesday, February 14, 2017 8:36 PM
Subject: Re: [oberheim] Re: Matrix 6 repair
Those are not error codes. It's the display reading crap. Try the initializer ion... Hold the red button, then power up. It should come up in calibration mode.
John Leimseider
Electronics Technician
Technicien en électronique
Mailing and Courier Address:
National Music Centre office
Studio Bell
Studio Bell, home of the National Music Centre
Now Open
On Feb 14, 2017, at 5:45 PM, 'Scott Rogers' scott@... [oberheim] < oberheim@yahoogroups.com > wrote:
HiI don’t know the error codes but my advice is to check the power supply voltages carefully. I found that minor variations (2-3volts) can cause weird things to happen in that synth.ScottFrom: oberheim@yahoogroups.com [ mailto:oberheim@yahoogroups.com ]
Sent: Tuesday, February 14, 2017 1:22 PM
To: oberheim@yahoogroups.com
Subject: [oberheim] Re: Matrix 6 repairO.K. the PC Control Board was replaced with a used board, had the display and patches working, now I am getting intermittent problems with the power switch and the display reads PW PPPPPPPPP or HHHHHHHHH. where can I find the descriptions for the error codes for the Matrix 6 Anyone know what these error codes indicate ...Thank You