Greetings,

I just picked up two m1000's and immediately connected them using
group mode. It all seems to work *except* bank changes are not being
received by the slave - it's as if bank lock was enabled on the slave
unit(but it's not).

so far I have:

combed through the manual ;)
reinitialized both units
swapped the cables to change the master/slave relationship
searched through the message archives here

no luck!

any ideas I imagine it's just simple user error

Thanks,

john


PS: I have the m1000's plugged into an ensoniq dp4 - 4u of pure
delight, and I haven't started programming yet!