I just tried it, but still no luck.

At the beginning of each sequence, I'm sending the bank select sysex,
then the program change etc. Does the enable go before the bank select

Where did you get that sysex string I can't find it documented
anywhere on the web or in the manual. Does the software rev have
anything to do with it

Thank you,

Stublito

Quoting "bernard.escaillas" < bernard@... >:

> You have to send a message once to enable 'remote sysex'.
>
> This message is F0 10 06 05 F7
>
> Note: the Matrix1000 has some bugs...
> Read more here: http://wolzow.mindworks.ee/analog/m1k-firmware.htm
>
> Be careful no to send sysex messages to fast or you will crash the
> Matrix... Even if MIDI bauds are always the same, today midi port
> buffers are a lot faster than in the 80's ;)
>
> Have fun
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>