Hi

one could add a larger cooling device to the regulator, but I assume
this would cause mechanical problem in transport (too much mass).

Florian

selfoscillate wrote:

> hello chuck,
>
> only one ad5 is allowed per row.
> as long as the total 5 volts consumption of the modules
> doesn't exceed 100ma you can use more than 1 module
> with the ad5. in the example below (a113 and a190)
> the 5 volts consumption is 150 ma, therefore you need
> two ad5.
>
> best wishes
>
> ingo
>
>
>
> --- In Doepfer_a100@yahoogroups.com , "charles graef"
> <vogelscheiss@...> wrote:
>
>>Sorry, I'm confused -- you're saying that the A-100AD5 will only
>
> permit one
>
>>5V module in the row in which it's installed
>>
>>--Chuck
>>
>>-----Original Message-----
>>From: Doepfer_a100@yahoogroups.com
>
> [mailto: Doepfer_a100@yahoogroups.com ] On
>
>>Behalf Of hardware@...
>>Sent: Friday, December 14, 2007 10:12 AM
>>To: Doepfer_a100@yahoogroups.com
>>Subject: AW: 1 5V Low-Cost Adapter questions
>>
>>
>>>I have two 5V Low-Cost Adapters (A-100AD5). I have previously
>
> used them
>
>>>with A-113 and A-190 installed in separate A-100G6 cabinets.
>>>
>>>Now I am going to put A-113 and A-190 into same cabinet. Looking
>
> at the
>
>>>power consumption figures it appears, that two A-100AD5 are still
>>>needed. Just to make to make sure, I would like to ask, how
>
> should the
>
>>>A-100AD5:s be installed, when
>>>- A-113 and A-190 are in the same row/power rail.
>>
>>Sorry, that's not possible as only one A-100AD5 is allowed for each
>
> bus
>
>>board.
>>
>>
>>>- A-113 and A-190 are in different rows.
>>
>>That's the right solution. Simple connect one A-100AD5 on each bus
>
> board.
>
>>Best wishes
>>Dieter Doepfer
>>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>

--
Florian Anwander |ConSol
Tel. +49(89)45841-133 |Consulting&Solutions Software GmbH
Fax +49(89)45841-111 |Franziskanerstr. 38, D-81669 München
email: florian.anwander@... | http://www.consol.de