Hi Florian,

thanks for the hint. you mean JP5 that looks properly soldered, like
all other solderjoints on the board.
and retriggering via LFO while holding down the gate, does retrigger.
however it depends on the sustain/decay pot settings. if both are low
the EG goes low when the retrigger signal goes high. if decay/sustain
are high (>3) then it retriggers.
however the overal env voltage seems low since the LED is quite dimm.

hel

--- In Doepfer_a100@yahoogroups.com , Florian Anwander
<Florian.Anwander@...> wrote:

>
> Hi helitr0n
>
>
> > one of the four EGs is not working properly:
> > when the sustain = 0, the output is high, without beeing triggered.
> > however, when a trigger/gate is applied, the envelope stops for the
> > duration of the signal, and then it goes high again.
> > with sustain >3, the envelopetriggering behaves normally, but the
> > output is too low compared to the other EGs on the module.
> > additionally, decay and relese also affect the triggering behaviour.
> I had a look at the schematics: this sounds like the wire bridge "J10"
> has been forgotten or is not solder correctly: it is close to the Decay
> potentiometer and the IC1 (a 555).
>
> How does the Envelope react on a slow rectangle LFO at retrigger in
> while the gate is high (key pressed).
>
> Florian
>