Hi group,
The manual of the A-190 MCVS states:
The gate output % and CV1 output & are automatically
connected to the system bus of the A-100, so
don't use patch cables to connect these, unless you
have cut the links, or wish to connect to a module
whose system bus isn't connected with the A-190's
(have a look at the note on using more than one
A-190). VCOs on the same system bus automatically
receive CV1, and ADSRs automatically receive
the gate signal.
I however need a gate signal to trigger Reset In of the A-145 LFO.
Can I patch the A-190 gate output to this Reset In (I think I can, but am still a bit afraid to ruin something, so please forgive me my ignorant questions).
Thanks in advance,
Ton