test

I don't have an A-185, but I think you are correct. The A-190 should provide CV/Gate to Case 1 (only the modules in the same 3U row as the A-190, unless you have the extra cable to connect your bus boards). The sockets on the A-190 can send the signals to the other case's A-185, so the A-111s and A-141 can be fed from the Case 2 system bus (again, only the same row as A-185 unless you have the bus board connection cable).

That should drive your VCOs without any tuning issues ... I think....

Nick

On Nov 6, 2013, at 12:23 AM, < karelvanbezooijen@... > wrote:

Please tell me if I'm right or wrong.

I have a few cases with modules:

Case 1: standard basic system 2 with 2 x VCO 110 and A-190
Case 2: another case with 3 x VCO 111 plus A-141 VCADSR.

In order to control Case 2 with the same gate and CV from the A-190 I only need an A-185-1 in Case 2.
When I connect The A-190 to the A-185-1 it should be allright, right

I read the A-185-1 manual but why should I also put an A-185-1 in Case 1

regards,
Karel van Bezooijen

previous	index	next
<<	topic list	>>

25133 Re: 1 Question about the A-185-1 module