Hi Dieter.
Thanks, as always, for the quick response. It´s page 8 in the A-161
manual. You can see a JPG of the page with the paragraph in a red
box in my photo album. (It´s Studio1dk: doepfer A161)

Keld

--- In Doepfer_a100@yahoogroups.com , "Dieter Doepfer"
<hardware@d...> wrote:

> At first sight I could not see that the A-161 manual says that +5V

appear at

> the outputs. In this case the manual would be wrong. The high

state of the

> A-160 and A-161 outputs are close to +12V. It does not matter

within the

> A-100 because any voltage beyond about +3V is treated as

logical "high" (+5V

> as well as +12V) from any digital input (e.g. gate, clock, reset).
>
> Best wishes
> Dieter Doepfer
>
> P.S. Please tell me where you found the +5V remark so that we can

correct

> the manual.
>
> > -----Ursprüngliche Nachricht-----
> > Von: Doepfer_a100@yahoogroups.com
> > [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von Keld Sørensen
> > Gesendet: Dienstag, 26. Juli 2005 13:30
> > An: Doepfer_a100@yahoogroups.com
> > Betreff: 1 A-161clock sequencer.
> >
> >
> > Hi all.
> > I just put an volt meter to the output of my A-161 checking the
> > voltage. My A-161 puts out +11.38 Volts when active - the manual

says

> > +5 Volts. Is this a fault in my system
> >
> > Keld