bakis,
hmm, your comment prompted me to measure these voltages. to my
surprise, here are the results: (i'm sure there's some variance from one
module to the next as well)

A155 triggers send 7-8v and the GATE sends 10v
A162 TRIG output is 10v
A177 foot controller GATE output is 12v (!!)
A178 theremin gate output is 8v,
A190 gate output is 10 v.
and just to make sure i'm not hallucinating, a 9v battery reads output of 9v.

so i don't know what's up w these reported specs..

the A129/3 must have slipped by me somehow, never realized the potential of
this module outside a vocoder system, and i now see it as a necessity. yikes!
duff



-- In Doepfer_a100@y..., bakis Sirros <synth_freak_2000@y...> wrote:

> hi dugg,
> i don't think that this will help because the problem
> is that the triggers from the a155 are from 0 to
> +12volts and that's the problem(gates are from 0 to +5
> volts)...but i think attenuating them with the a129/3
> will be the solution...
> synthfreak
>
> --- duffnuff <duffnuff@h...> wrote:
> > --- In Doepfer_a100@y..., bakis Sirros
> > <synth_freak_2000@y...>
> > wrote:
> > > no,RM,
> > > i mean that,if i connect one of the triggers
> > output of
> > > my a155 to the i/o jacks of the a150 ,that they
> > pass
> > > right thru the switch...not in the CV jack.
> > > bakis.
> >
> >
> > bakis,
> > i dont have a 150 to see what you mean..but if you
> > have a 162
> > does that help (maybe this has already been
> > suggested) i use
> > the 162 on the 155 trigs to turn them into gate
> > signals when
> > necessary. set delay time to '0' and vary the
> > length to set gate
> > time.
> > duff
> >
> >
>
>
> =====
> synthfreak(parallel worlds)
> athens-greece
> 1 group owner-moderator
>
> __________________________________________________
> Do You Yahoo!
> Yahoo! Greetings - Send FREE e-cards for every occasion!
> http://greetings.yahoo.com