What other way would you suggest? I could go back to using sysex to address the various synths but it's not very nice and not everything can handle sysex which is why I dropped it. I guess I could make a CC command to select the synth which would change the synth selected on the PE the same as using the menu buttons on the PE. You would still need to have the synths on separate midi channels or eveything would get very confused.

Murray

--- In kiwitechnics@yahoogroups.com , "cramseur2000" <cram@...> wrote:
>
> Alas, I was hoping for another way.
>
> <roups.com, Kiwitechnics <yahoogroups@> wrote:
> >
> > Each synth in the PE has a midi channel attached (menu level 2). These
> > can all be different. So for example set the MKS-80 to channel 1,
> > Cheetah to ch2 and the 8P to ch3 then set these same numbers into the PE
> > and daisy chain the midi using the midi through ports. The PE input also
> > has it's own midi ch number(menu level 3). This will enable the PC to
> > send to the PE on the one channel and control which ever synth you have
> > selected on the PE menu using the generic CC commands. Currently the PE
> > is not translating the midi note data only because I hadn't though of it
> > but this would be a simple mod if anyone thinks it is required.
> >
> > Murray
> >
> >
> >
> > On 5/08/2011 4:18 p.m., cramseur2000 wrote:
> > >
> > > Has anyone figures out an easy way to control multiple synths from one
> > > PE without connecting and disconnecting from each synth?
> > >
> > > I currently have an MKS-80, Cheetah MS6, and a JX-8p.
> > > I only have one PE.
> > >
> > > I need each synth to have access to my sequencer, and to the PE at the
> > > same time, so I don't have to continuously patch/re-patch.
> > >
> > > Thanks!
> > >
> > > Craig
> > >
> > >
> >
>